- Mon Jul 24, 2017 9:15 pm
#298961
In case you haven't been following my plant drama, I had a plant that was darkening around the petioles and traps and posted about it on here. I was told it looked like mineral burn. I decided to flush my plant with 49ppm water and measure the water when it came out of the drainage holes to see if there was a problem mineral wise. There was as the water was 72ppm. I know this is far too high, so how do I reverse it? just flush the plant with pure water until the drain off reads below 50ppm?
"FEED ME!" - Audrey II, from Little Shop of Horrors